LG L90 (lg-w7)
 LG L90 | |
| Manufacturer | LG |
|---|---|
| Name | Optimus L90 |
| Codename | lg-w7 |
| Released | 2014 |
| Type | handset |
| Hardware | |
| Chipset | Qualcomm Snapdragon 400 (MSM8226) |
| CPU | Quad-core 1.2 GHz Cortex-A7 |
| GPU | Adreno 305 |
| Display | 540 x 960 IPS LCD |
| Storage | 8GB |
| Memory | 1GB |
| Architecture | armv7 |
| Software | |
Original software  The software and version the device was shipped with. |
Android 4.4.2 |
| postmarketOS | |
| Category | downstream |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
no |
| Device package |
 device-lg-w7 |
| Kernel package |
linux-lg-w7 |
Flashing It is possible to flash the device with pmbootstrap flasher. |
Broken
|
|---|---|
USB Networking After connecting the device with USB to your PC, you can connect to it via telnet (initramfs) or SSH (booted system). |
Works
|
Battery Charging and battery level reporting works |
Untested
|
Screen Display works. Ideally with sleep mode and brightness control. |
Untested
|
Touchscreen |
Untested
|
| Multimedia | |
3D Acceleration |
Untested
|
Audio Audio playback, microphone, headset and buttons. |
Untested
|
Camera |
Untested
|
IR TX |
Untested
|
| Connectivity | |
WiFi |
Untested
|
Bluetooth |
Untested
|
GPS |
Untested
|
NFC Near Field Communication |
Untested
|
| Modem | |
Calls |
Untested
|
SMS |
Untested
|
Mobile data |
Untested
|
| Miscellaneous | |
FDE Full disk encryption and unlocking with unl0kr. |
Untested
|
USB OTG USB On-The-Go or USB-C Role switching |
Untested
|
| Sensors | |
Accelerometer Auto screen rotation works in desktops e.g. Phosh or Plasma Mobile |
Untested
|
Contributors
MelronTorkin
Users owning this device
- Kirjoittamaton (Notes: PMOSok & SSHok)
How to enter flash mode
Instructions are shared between this device and others from the same manufacturer (LG). The detailed steps can be found here https://wiki.postmarketos.org/wiki/LG_G3_Europe_(lg-d855).
Booting using pmbootstrap flasher boot does succesfully boot the device, allowing ssh connection via USB.
Installation
At the moment flashing is not working, so it is necessary to install to sdcard and then live boot from fastboot.
Installing to sdcard works with the command
- Replace /dev/sdX with the device for your sdcard
$ pmbootstrap install --sdcard /dev/sdX Now place the sdcard into the phone. Assuming that the bootloader is unlocked, it is possible to get to fastboot by following steps
Disconnect and reconnect the battery. Hold volume up while connecting phone to computer with a usb cable. Now it is possible to live boot.
$ pmbootstrap flasher boot
Photos
|