Prestigio MultiPad PMT5008 3G (prestigio-pmt5008-3g)
| This device is marked as not booting. Status: No kernel sources, but mainline starts up and serial console works |
|
CHANGE_ME CHANGE_ME | |
| Manufacturer | Prestigio |
|---|---|
| Name | MultiPad PMT5008 3G |
| Codename | prestigio-pmt5008-3g |
| Released | 2016 |
| Hardware | |
| Chipset | MediaTek MT8382 |
| CPU | 4x1.3 GHz Cortex A7 |
| GPU | Mali-400 MP2 |
| Display | 1280x800 IPS |
| Storage | 8 GB |
| Memory | 1 GB |
| Architecture | armv7 |
| Software | |
Original software  The software and version the device was shipped with. |
Android 4.4 |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
no |
| This device is based on the MediaTek MT6582. See the SoC page for common tips, guides and troubleshooting steps |
Contributors
- km2
Users owning this device
- Km2 (Notes: I'm trying to port mainline)
How to enter flash mode
Installation
Mainline Kernel Status
There is no downstream kernel source code for this device. So I decided to port mainline linux and I was pretty quick to successfully start 4 uart ports, wdt, smp and /bin/sh from initramfs. But for further progress, you need to write the pinctrl and clk drivers.
Also this device uses pmic mt6323 which seems to be in mainline.