Solidrun CuBox (solidrun-cubox)

U-Boot
Primary Bootloader It is possible to replace stock bootloader with U-Boot.	Works
Secondary Bootloader It is possible to chainload U-Boot from stock bootloader.	Works
Mainline Latest versions of U-Boot are not broken and it is possible to use them.	Broken
Internal Storage It is possible to boot from internal storage (e.g. eMMC or UFS).	Works
SD card It is possible to boot from SD card.	Works
USB Host It is possible to boot from a USB storage or connect a keyboard.	Works
USB Peripheral It is possible to use device as a peripheral in U-Boot, e.g. for fastboot mode.	Works

Features
SD card Also includes other external storage cards	Works
Multimedia
3D Acceleration	Works
Audio Audio playback, microphone, headset and buttons.	Partial
IR RX	Works
Connectivity
Ethernet	Works
Miscellaneous
USB-A Full-sized USB-A port works (Usually applicable to SBCs and laptops).	Works
SATA/eSATA	Works
HDMI/DP Video and audio output with HDMI or Display Port works.	Partial

Solidrun CuBox
	; CuBox on Desk (note the size compared to the connector)
Manufacturer	Solidrun
Name	CuBox
Codename	solidrun-cubox
Model	cubox
Released	2011
Type	embedded
Hardware
Chipset	Marvell Armada 510 (88AP510)
CPU	Marvell Sheeva @ 800 MHz
GPU	Vivante
Display	none
Storage	none
Memory	1 GB
Architecture	armv7
Software
Original software The software and version the device was shipped with.	Ubuntu 10.04
FOSS bootloader	partial
postmarketOS
Category	testing
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline.	yes
pmOS kernel The kernel version that runs on the device's port.	6.14.4
Unixbench score Unixbench Whetstone/Dhrystone score. See Unixbench.	118.5
Device package	device-solidrun-cubox
Kernel package	linux-postmarketos-marvell

The Solidrun CuBox is the first in a series of small and fanless nettop-class computers manufactured by the Israeli company SolidRun Ltd.

This port covers the Marvell Armada 510 (88AP510) based first revision.

This device is based on the Armada 510. See the SoC page for common tips, guides and troubleshooting steps

Installation

Use pmbootstrap to build your own installation image, install to sd-card is currently the only option.

$ pmbootstrap init
# select edge, solidrun, cubox
$ pmbootstrap install --disk /dev/sdX

Note: installation to USB-memory or HDD should also be possible, but would require a modified `boot.src`

HDMI: investigate to get working
SPDIF/TOSLink (audio-out): investigate to get working
RC-receiver seem to work, but not really tested up to now
Kernel: optimize config (community-config check passes, could still need optimization for auxiliary modules)